TablesJ Design of connections
Table J3.4: Minimum Edge Distance[a] from Center of Standard Hole[b] to Edge of Connected Part
PDF page 207 · AISC 360-22
| Bolt Diameter | Minimum Edge Distance |
|---|---|
| 1/2 | 3/4 |
| 5/8 | 7/8 |
| 3/4 | 1 |
| 7/8 | 1 1/8 |
| 1 | 1 1/4 |
| 1 1/8 | 1 1/2 |
| 1 1/4 | 1 5/8 |
| Over 1 1/4 | 1 1/4d |
[a] If necessary, lesser edge distances are permitted provided the applicable provisions from Sections J3.11 and J4 are satisfied, but edge distances less than one bolt diameter are not permitted without approval from the engineer of record.
from the engineer or record. [b]For oversized or slotted holes, see Table J3.5.